Woodmaster 4400 Maintenance Kit For Outdoor Wood Boiler Treatment
Maintenance Kit - 4400 Includes Fire Rope for 4400, 1- Fan Cover FC546, 1- Tube of RTV Silicone and One Gallon Protech 300
The WoodMaster 4400 Yearly Maintenance Kit has everything you will Need to Tune Up your WoodMaster!
The Yearly Maintenance Kit Includes:
- Fire Rope
- Silicone (to mount Fire Rope and Seal around Chimney and other areas if needed)
- Fan Cover
- ProTech300 Boiler Treatment
WoodMaster recommends that all these parts be replaced Yearly!
This will greatly prolong the life of your Fans/Blowers and make your WoodMaster run like the day you bought it. You should drain all the water and refill your WoodMaster with fresh water also before adding the Boiler Treatment in. The whole job of replacing the maintenance parts should only take about 20 minutes. Easy Job... Be Self-Sufficient...
WoodMaster 4400 furnace
- To replace FC546 fan cover, take the four screws out that hold cover over fan out and remove cover. Use 1/4" wrench to remove screws that are holding fan cover to fan and unhook old fan cover from laminated solenoid LS001. Change fan cover and do directions backwards.
- To install fire rope simply pull out old fire rope, scrap the area clean, apply bead of silicone in the channel and add rope. Yes it is that easy!
boiler maintenance says:
wood chew says:
Skinny KS says:
D&D Farms says:
Write Your Own Review
This Kit is all you need to keep your WoodMaster 4400 model running like the day you bought it! The Kit includes; One tube of RTV Silicone, Black, 10 oz One Gallon ProTech Boiler treatment (2 year supply/ 1/2 gallon is all you need each year), One FC546 Fan Covers and Fire rope for the door. These Parts should be replace yearly.
To Install Fire rope simply pull out old fire rope, scrap the area clean, use regular household silicone in the channel and add rope. Yes it is that easy!
To replace FC546 fan cover: Take the four screws out that hold cover over fan out and remove cover. Use 1/4" wrench to remove screws that are holding fan cover to fan. Unhook old fan cover from Laminated solenoid LS001. Change fan cover and do directions backwards.